Haws 7324 features the medically acclaimed AXION MSR eye/face wash head assembly (patent pending). This revolutionary inverted flow design is the only product on the market that provides a Medically Superior Response consistent with all EMT, emergency room and doctors’ office protocols by sweeping contaminants away from the vulnerable nasal cavity. Traditional eyewashes irrigate from the outside edge of the eye back toward the nose, where contaminants can then be flushed into the nasal cavity through the lacrimal punctum, nature’s ocular cavity drain.
- Unit is equipped with a pop-off dust cover, so when debris is present, the irrigation process stays protected
- Easily detected and maintained, emergency equipment is equipped with safety sign and test card to record weekly testing
- Reducing installation time, eye/face wash and valve assembly is pre-built and fully water/pressure tested
- Floor drain is recommended for this unit
- ANSI/ISEA Z358.1 tempering compliance options
Certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment.
7360B-7460B – AXION® MSR Wall Mount Eye/Face WashModel 7360B-7460B wall mounted, eye/face wash features the medically acclaimed AXION MSR eye/face wash head assembly (patent pending). This revolutionary inverted flow design is the only product on the market that provides a Medically Superior Response consistent with all EMT, emergency room and doctors’ office protocols by sweeping contaminants away from the vulnerable nasal cavity. Traditional eyewashes irrigate from the outside edge of the eye back toward the nose, where contaminants can then be flushed into the nasal cavity through the lacrimal punctum, nature’s ocular cavity drain.
- Eyewash streams provide Zero Vertical Velocityâ„¢ engineering with even laminar flow for enhanced comfort, stability and effectiveness
- Features a round 11″ (27.9 cm) stainless steel receptor and aluminum wall bracket for long life
- Includes a mesh in-line strainer to collect line debris, and ball valve with stainless steel ball and stem for durability
- Supply: 1/2″ NPT. Waste: 1- 1/4″ NPT
- ANSI/ISEA Z358.1 tempering compliance options
Certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment.
Due to technology advancements these (two models) are now the same.
7360BTWC – AXION® MSR Barrier-Free Eye/Face WashThe Haws 7360BTWC barrier-free emergency eye/face wash features the medically acclaimed AXION MSR eye/face wash head assembly (patent pending). This revolutionary inverted flow design is the only product on the market that provides a Medically Superior Response consistent with all EMT, emergency room and doctors’ office protocols by sweeping contaminants away from the vulnerable nasal cavity. Traditional eyewashes irrigate from the outside edge of the eye back toward the nose, where contaminants can then be flushed into the nasal cavity through the lacrimal punctum, nature’s ocular cavity drain. Unit is equipped with an in-line 50 x 50 mesh water strainer and flip top dust covers, so when debris is present, the irrigation process stays protected. Space efficient design allows the 7360BTWC to be mounted in a number of easily accessible locations while providing a barrier-free standard.
-
- Low profile design accommodates wheelchair access
- Eyewash streams provide Zero Vertical Velocityâ„¢ stream engineering with even laminar flow for enhanced comfort, stability and effectiveness
- Reducing installation time, eye/face wash and valve assembly is pre-built and fully water/pressure tested. Unit also comes with trap and tailpiece to meet desired wall mounting requirements
- ANSI/ISEA Z358.1 tempering compliance options
Certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment.
7460 – AXION® MSR Unmounted Eye/Face WashModel 7460 unmounted eye and face wash features the medically acclaimed AXION MSR eye/face wash head assembly (patent pending). This revolutionary inverted flow design is the only product on the market that provides a Medically Superior Response consistent with all EMT, emergency room and doctors’ office protocols by sweeping contaminants away from the vulnerable nasal cavity. Traditional eyewashes irrigate from the outside edge of the eye back toward the nose, where contaminants can then be flushed into the nasal cavity through the lacrimal punctum, nature’s ocular cavity drain.
- Eyewash streams provide Zero Vertical Velocityâ„¢ stream engineering with even laminar flow for enhanced comfort, stability and effectiveness
- Features a round 11″ (27.9 cm) stainless steel receptor
- Includes a mesh in-line strainer to collect line debris, and ball valve with stainless steel ball and stem for durability
- Supply: 1/2″ NPT. Waste: 1- 1/4″ NPT
- ANSI Z358.1 tempering compliance options
Certified by CSA to meet the ANSI Z358.1 Standard for Emergency Eyewash and Shower Equipment.
7500EB – Portable Self Contained Heated EyewashHaws heated portable Model 7500EB is ideal for remote locations. Using gravity to supply a continuous flow of clean water to injured personnel for a full 15 minutes at .4 gpm (1.5 L), this model is a reliable source for safety. The 7500’s full patterned flushing feature is capable of being used in sub-freezing temperatures.
- Featuring a FDA approved high-density green polyethylene tank easily activated by pulling the yellow activation arm down to the open position
- 1000 Watt, 120 VAC submersible thermostatically controlled heater element
- Fully functional to -30° F (-34.4° C) and should stay between 65° and 75° F (18.3 and 23.9° C)
- Model supplied with 9′ (274.3 cm) power cord, 3-prong plug, and fitted insulated protective cover
- A wide-fill opening with threaded cap permits easy inspection, cleaning and filling
- Relocation is simple due to the easily mounted (bracket included) and light design of this 16 gallon (60.6 L) portable
- Measurements: 22-1/2″ high, 21-1/2″ wide, 19-1/2″ deep (57.2 x 54.6 x 49.5 cm)
Model 7500EB is certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment.
7501 – Portable Gravity Fed EyewashThe newly retooled Haws 7501 compact portable eyewash is a 9-gallon (34.1 L) capacity gravity operated portable eyewash that supplies a continuous flow of water for a full 15 minutes at .4 gpm. This unit is a cost-effective solution ideal for locations without access to potable water, including temporary decontamination sites, temporary treatment facilities, and short-term job sites.
Product enhancements include:
- Featuring a FDA approved high-density green polyethylene tank that is easily activated by pulling the yellow activation arm down to the open position
- A wide-fill opening with a securely threaded cap, and a pronounced ‘Max Fill’ line permits easy inspection, cleaning and filling
- Relocation is simple due to ‘Lift Here’ graphics, easily mounted bracket (included) and light design of this 9-gallon (34.1 L) portable
- Measurements: 14-1/2″ high, 22″ wide, 10-1/8″ (36.8 x 55.9 x 25.7 cm) deep. *Note: Unit must be wall hung
Certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment. This is clearly called out on the exterior of the unit.
7501T – Tempered, Gravity-Fed, Portable EyewashThe newly retooled Haws 7501T compact portable tempered eyewash ideal for remote locations. The 9-gallon (34 L), gravity-fed, eyewash uses a heated, insulated blanket to provide ANSI compliant tempered potable water in operating temperatures between -20° F (-30° C) and 100° F (38° C) for locations without access to a continuous potable water source. 120VAC, 60Hz, 1.38A electrical requirement with supplied 8′ power cord. This unit is a cost-effective solution ideal for locations without access to potable water, including temporary decontamination sites, temporary treatment facilities, and short-term job sites.
- A wide-fill opening with a securely threaded cap, and a pronounced “Max Fill” line that permits easy inspection, cleaning and filling
- FDA approved high-density green polyethylene tank that is easily activated by pulling the yellow activation arm down to the open position
- Ease of relocation due to “Lift Here” graphics, easily mounted bracket (included) and light design
- Measurements: 16″ high, 24″ wide, 12″ deep (36.8 x 55.9 x 25.7 cm). *Note: Unit must be wall hung
QPS-C-US-Certified-Electrical-Safety for NEMA/Type 3R in ordinary locations, and to ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment, which is clearly called out on the exterior of the unit.
4110ADA – Enameled Iron Deck SinkDeck mounted sink units like the 4110ADA are installed in accessible countertop locations for quick locating and convenient operation. Sunken down sink design with water tight fit and stainless steel mounting rim helps to minimize excess splashing, keeping the drinking area contained.
- White acid-resistant enameled iron sink makes for one of the toughest mounting surfaces Haws produces
- Measurements are 24″ x 16″ x 5″ (61 x 40.6 x 12.7 cm)
- Mounted at the correct height and equipped with proper drinking fountain and faucet, this unit complies with the Americans with Disabilities Act requirements for drinking fountains
Specify one of the following gooseneck faucets to be installed left rear side:
Model 5510LF stay-open lever handle, polished chrome-plated brass gooseneck faucet,
Model 5452LF, self-closing lever handle polished chrome-plated brass gooseneck faucet, or
Model 5530LF stay-open, hot and cold lever handle, polished chrome-plated brass gooseneck faucet.
Specify the following bubbler to be installed on right front side;
Model 5054LF lever handle polished chrome-plated brass drinking faucet,
Model 5017LF push button polished chrome-plated brass drinking faucet with renewable cartridge and vandal resistant lock pin, or
Model 5051LF self-closing lever handle drinking faucet with a polished chrome-plated brass finish, adjustable stream flow, and vandal resistant lock pin.
4210 – Deck SinkDeck-mounted sink units like the 4210 are installed in accessible countertop locations for quick locating and convenient operation. Sunken down sink design helps to minimize excess splashing and self-rimming feature allows for easy mounting.
- Stainless steel construction offers a good amount of durability and corrosion resistance
- Beautiful satin finish resists stains and corrosion
- Sitting watertight along with sound deadening underneath keep this unit mounted securely on any countertop
- Measurements are 25″ x 17″ x 5″ (63.5 x 43.2 x 12.7 cm)
- Mounted at the correct height and equipped with proper drinking fountain and faucet, this unit complies with the Americans with Disabilities Act requirements for drinking fountains
Haws manufactures drinking fountains and electric water coolers to be lead-free by all known definitions including NSF/ANSI Standard 61, Section 9, California Proposition 65, and the Federal Safe Drinking Water Act.
Specify one of the following gooseneck faucets to be installed left rear side:
Model 5510LF stay-open lever handle, polished chrome-plated brass gooseneck faucet,
Model 5452LF self-closing lever handle polished chrome-plated brass gooseneck faucet or,
Model 5530LF stay-open, hot and cold lever handle, polished chrome-plated brass gooseneck faucet.
Specify the following bubbler to be installed on right front side:
Model 5054LF lever handle polished chrome-plated brass drinking faucet,
Model 5017LF push button polished chrome-plated brass drinking faucet with renewable cartridge and vandal resistant lock pin, or
Model 5051LF self-closing lever handle drinking faucet with a polished chrome-plated brass finish, adjustable stream flow, and vandal resistant lock pin.
4230 – Deck SinkDeck-mounted sink units like the 4230 are installed in accessible countertop locations for quick locating and convenient operation. Sunken down sink design helps to minimize excess splashing and self-rimming feature allows for easy mounting.
- Stainless steel construction offers a good amount of durability and corrosion resistance
- Beautiful satin finish resists stains and corrosion
- Sitting watertight along with sound deadening underneath keep this unit mounted securely on any countertop
- Measurements are 31″ x 19″ x 5″ (78.7 x 48.2 x 12.7 cm)
- Mounted at the correct height and equipped with proper drinking fountain and faucet, this unit complies with the Americans with Disabilities Act requirements for drinking fountains
Haws manufactures drinking fountains and electric water coolers to be lead-free by all known definitions including NSF/ANSI Standard 61, Section 9, California Proposition 65, and the Federal Safe Drinking Water Act.
Specify one of the following gooseneck faucets to be installed left rear side:
Model 5510LF stay-open lever handle, polished chrome-plated brass gooseneck faucet.
Model 5452LF self-closing lever handle polished chrome-plated brass gooseneck faucet or,
Model 5530LF stay-open, hot and cold lever handle, polished chrome-plated brass gooseneck faucet.
Specify the following bubbler to be installed on right front side:
Model 5054LF lever handle polished chrome-plated brass drinking faucet.
Model 5017LF push button polished chrome-plated brass drinking faucet with renewable cartridge and vandal resistant lock pin, or
Model 5051LF self-closing lever handle drinking faucet with a polished chrome-plated brass finish, adjustable stream flow, and vandal resistant lock pin.
4010 – Deck FountainDeck-mounted units like the 4010 are installed in accessible countertop locations for quick locating and convenient operation. Push button operated stainless steel bubbler valve with adjustable stream regulation make this fountain easily activated and maintained. Slope down stream guide minimizes splashing, keeping the surrounding area clean. Equipped with mounting bracket and waste strainer, this fountain is vandal resistant and easily placed.
- Stainless steel construction offers a good amount of durability and corrosion resistance
- 100% lead-free waterways
- Anti-squirt flow prevents surging water, keeping the drinking area contained and clean
Haws manufactures drinking fountains, faucets and electric water coolers to be lead-free by all known definitions including NSF/ANSI/CAN 61- Section 9, NSF/ANSI/CAN 372, California Proposition 65, and the Federal Safe Drinking Water Act. Product is compliant to California Health and Safety Code 116875 (AB 1953-2006), and 116876 (AB 100) “NSF/ANSI/CAN 61: Q ≤ 1”.